Workers’ Comp Class Code 5645: Residential Carpentry
If you build or remodel houses in California and went looking for class code 5645, you won’t find it on the WCIRB’s list. California reports home carpentry in 5403 or 5432, sorted by wage, and this page maps where each part of a residential job is reported instead.
Is 5645 a California class code?
No. The WCIRB’s Uniform Statistical Reporting Plan, which sets the classes for every California policy, has no 5645, and the approved advisory rate table for September 1, 2026 lists no rate for it. The number belongs to the classification system used by NCCI states, where it is a residential carpentry code and 5403 is kept mainly for commercial work and taller buildings. California draws its carpentry lines differently, and everything below follows the California plan.
A 5645 tends to show up when a contractor compares notes with builders in other states, reads a national code list, or holds an older quote prepared on another state’s system. For California employees, the codes on the policy have to come from the WCIRB’s list.
Where house framing goes instead
California’s carpentry classes cover rough carpentry, or rough and finish work together, in new construction or remodeling of residential or commercial buildings. No separate wood carpentry class exists for houses, duplexes, townhomes or apartment buildings, and none is set by the number of stories or units. The framer of a single-family home and the framer of a mid-rise office use the same pair.
That pair is split by pay. Class code 5403 takes carpenters below the hourly threshold, and class code 5432 takes those at or above it, $46.00 for policies starting on or after September 1, 2026, once time records prove the wage. A residential builder’s workers’ comp cost turns far more on that wage split than on what kind of home is going up.
A home build, trade by trade
Residential jobs mix trades, and each has its own place in the plan. Here is how the common ones are classified in California:
- Framing and other rough carpentry by your own carpenters, with the trim, doors and cabinets they hang as part of it: 5403 or 5432.
- Shingle roofing or insulation done by the same company framing the new house or addition at that job: stays in carpentry.
- Insulation installed by a separate company: 5479. Roofing other than that shingle case: 5552 or 5553.
- Drywall hanging and finishing: 5446 or 5447.
- Cabinets, fixtures or trim with no rough carpentry by you at the job: 5146(1).
- Prefabricated doors, door frames or pre-glazed windows with no rough carpentry at the job: 5107.
- Cold-formed steel stud framing: 5632 or 5633.
- Building, setting or stripping forms for the foundation: the concrete classes.
Painting crews have their own page, class code 5474. Where one employee moves between trades, keep daily records of the operation as well as the hours so each block of time lands in its own class.
Teardowns and tear-outs on residential jobs
Knocking down an old wood-frame house before a rebuild counts as wrecking, and the plan sends wrecking or demolition of wooden buildings to 5403 or 5432. Taking out a whole floor or an exterior wall brings the same rule into play, though most of the house is left standing.
Smaller remodel tear-outs work differently. When nothing is razed and no floor or exterior wall comes out, removing old wallboard, flooring, framing or fixtures is classified with the trade that installs that material. Pulling drywall ahead of new drywall is wallboard work, not carpentry.
When a quote or audit shows the wrong code
If a California quote, policy or audit report lists 5645, ask the insurer which California class it means before you sign or pay. The WCIRB’s free online Classification Search shows each class’s wording, so you can compare it with what your crews actually do. The WCIRB or the insurer settles the class; neither we nor a payroll service can.
Timing matters when a class changes. If a correction moves you to a higher-rated class, it reaches back to the start of the wrong assignment only when the new class is published, or the WCIRB was told in writing, within three months of that start. Otherwise the change runs from publication. Either way, the sooner a wrong class is caught, the less payroll is reported under it before the audit.
What residential carpentry costs to insure
The WCIRB’s approved advisory pure premium rates from September 1, 2026, per $100 of payroll, give a sense of scale for the classes on a home job: 12.075 for 5403, 5.321 for 5432, 6.233 for 5446, 3.249 for 5447, 5.419 for 5479 and 20.827 for 5552. These are loss-cost benchmarks, not prices. They leave out insurer expenses, insurers file their own rates, and an experience mod, where the employer has one, moves the result again.
When we request workers’ compensation quotes for a home builder or remodeler, we describe each crew’s work and pay band so the insurer can assign the California classes after reviewing them. Our contractor insurance page and the California class code guide cover the rest of a builder’s program.
A few useful answers
Common questions
Does California use workers comp code 5645?
No. The WCIRB’s plan and its 2026 advisory rate table have no 5645. Carpentry on homes and on commercial buildings goes to 5403 or 5432, depending on the carpenter’s regular hourly wage.
What class code covers framing a single-family house in California?
Carpentry, 5403 or 5432. Carpenters below the hourly threshold go in 5403, and those at or above it go in 5432 once time records verify the wage.
Is apartment or townhouse carpentry a different class from house carpentry?
Not in California. The carpentry classes cover residential and commercial buildings alike, with no split by the number of units or stories.
Which code covers demolishing an old wood-frame house before a rebuild?
The carpentry classes, 5403 or 5432. The plan assigns wrecking or demolition of wooden buildings to them, and the same applies when a floor or an exterior wall is removed.
Can Mithril1 find workers’ comp for my home-building crew?
It can, when an insurer looks over your crews’ work and payroll and decides to quote. We send that detail with the application so the classes are set from the start.
